Davie Roofline logo
Stucco hip-roof house halfway through a tile re-roof, with black self-adhered underlayment on one side and new terracotta barrel tile stacked along the ridge

Roof replacement and repair referrals · Davie, FL

Flat Roof Repair and Replacement in Davie, FL

  • Repair: $300 to $1,100 on average, or $2.50 to $10.00 per sq ft; HomeGuide puts a minor leak at $150 to $500
  • Replacement: $3 to $11 per sq ft, or $4,000 to $16,800 on average
  • Coating: $1 to $4 per sq ft, usually $500 to $2,000 in total
  • Time on the roof: HomeGuide's general re-roof range is 1 to 8 days, set by material, size and complexity

Davie Roofline lets you reach a contractor for the flat section over your Florida room, carport or addition, whether it needs a patch, a coating or a new membrane. All of these figures are HomeGuide averages from across the country, so read them as a starting range rather than a price for your roof. Flat roofs fail at seams, edges and low spots, and the fix depends on which of the systems below is up there now.

Get a free roofing estimate

Free for homeowners, HOAs and property managers. One local contractor contacts you.

Flat Roof Systems on Davie Homes

White TPO membrane with heat-welded seams covering a low-slope roof on a single-story stucco addition

TPO Membrane

TPO is a single-ply sheet of plastic and rubber, usually white, which HomeGuide notes reflects heat. Published figures:

  • Cost: $4 to $10 per sq ft installed, or $7,700 to $14,000 for a typical roof.
  • Lifespan: 10 to 25 years per HomeGuide; InterNACHI's chart is more cautious at 7 to 20.
  • Upkeep: coating and sealing may lengthen its life.
Roofer seen from a distance unrolling a granulated modified bitumen cap sheet across a flat roof

Modified Bitumen (Torch-Down and Self-Adhered)

Modified bitumen is a flexible, asphalt-based roll roofing. HomeGuide prices it at $4.00 to $7.50 per sq ft, or $4,900 to $14,600 installed, and says it is UV-resistant and lasts 10 to 20 years. Torch-down sheets cost $3.50 to $7 per sq ft and are bonded with an open flame; self-adhered sheets stick down without one. HomeGuide lists torches and hot tar as a downside of some flat systems, so ask which method the quote assumes.

Built-up tar and gravel roof surface with a metal edge strip on a flat-roofed carport

Built-Up Roofing

A built-up roof is two or more layers of felt cemented together and topped with a cap sheet, gravel or a coating (the Florida code's definition). HomeGuide puts it at $3.50 to $7.50 per sq ft, or $4,500 to $12,600, with a life of 20 to 30 years. In the hurricane zone, the code calls for inspections during or after the base sheet goes on and again while the cap sheet is installed (FBC 1512.4.2.1 and 1512.4.2.2).

Roller applying a bright white silicone coating over an aged flat roof membrane

Silicone and Acrylic Roof Coatings

A coating renews the surface of a sound flat roof. It doesn't replace one. HomeGuide compares the two common types:

  • Silicone: $1.50 to $4.50 per sq ft installed, lasts 10 to 15 years, resists leaks from ponding water, but attracts dirt and gets slippery when wet.
  • Acrylic: $0.50 to $3.00 per sq ft, lasts 7 to 20 years, and is better suited to sloped roofs.

In Broward, repairs must use roofing components that hold a product approval (FBC 1521.2).

Junction where a white flat roof membrane turns up under the edge of a concrete tile slope with metal flashing

Where a Flat Roof Meets the Main Roof

The joint between a flat section and the sloped roof above it is where two different systems overlap. The hurricane-zone code splits roofs at 2:12: steeper slopes follow the tile, shingle and metal rules in FBC 1518, and anything flatter needs a low-slope system. Mortar- or adhesive-set tile can't go below 2:12 (FBC Table 1515.2). Ask how the membrane will be flashed up under the tile or shingle edge, and whether both roofs go on one permit. HomeGuide also flags parapet caps and their flashing as a cost item on flat roofs.

Gloved hands lifting a terracotta barrel tile beside a metal valley flashing on a tile roof

Why Davie homeowners, HOAs and property managers call Davie Roofline

  • One request goes to one independent roofer, not a list of five
  • Ask for an inspection and a written scope before any deposit
  • Ask to see the product approval (NOA) number for every material quoted
  • Ask the roofer to name who pulls the Town of Davie permit
  • Hold the final payment until Davie's final inspection passes

Get a free roofing estimate

Free for homeowners, HOAs and property managers. One local contractor contacts you.

Ponding and Drainage Rules for Flat Roofs

Broward's hurricane-zone reroofing rules spell out what a flat roof job has to respect:

  • Ponding

    repairs must not create more ponding (FBC 1521.3), and before work starts the contractor must tell the owner if ponding is possible and recommend a structural review (1521.13).
  • Drains

    the number or size of required scuppers and roof drains can't be reduced unless a design professional designs a new drainage system (FBC 1514.4.2.2).
  • Slope

    on new construction, the deck must slope at least 1/4 inch per foot (FBC 1515.2.2.1).

Roofing Over an Old Flat Roof

The same code allows one added roofing system over the original if the old assembly qualifies (FBC 1521.9). The checks are specific:

  • Moisture

    a survey must show no more than 5% moisture by weight in the membrane and 8% in board insulation (FBC 1521.12).
  • Bonded recovers

    the old membrane must pass an uplift test (FBC 1521.10).
  • Sheathing

    water-soaked or deteriorated sheathing must come out and be replaced first (FBC 1521.5).

For upkeep, HomeGuide suggests sweeping a flat roof and clearing its gutters every six months and after storms. How the Town permits a re-roof is covered on roof replacement. Flat roofs on manufactured homes have their own page at mobile home roofing, and plazas and offices are on commercial roofing.

Frequently asked questions

Water sits on our back-porch roof for a day after a storm. Should we worry?

It's worth a look. HomeGuide lists pooling water as a drawback of flat roofs, and Broward's hurricane-zone code says repairs must not create more ponding. Before a re-roof, the contractor has to tell the owner if ponding is possible and recommend a structural review when it is. A silicone coating resists ponding, but it doesn't fix a low spot.

Can a coating buy us a few more years before a new membrane?

It can: HomeGuide says coating a flat roof increases its lifespan. It puts silicone at $1.50 to $4.50 per sq ft with a 10 to 15 year life, and acrylic at $0.50 to $3.00 with 7 to 20 years. In the hurricane zone, repairs must use roofing components that carry a product approval, so ask for the coating's approval number.

TPO or modified bitumen for a small room addition?

Both are common. HomeGuide prices TPO at $4 to $10 per sq ft with a 10 to 25 year life, and modified bitumen at $4.00 to $7.50 with 10 to 20 years. It also notes that TPO, built-up and PVC suit hot climates, while EPDM and modified bitumen do well in cold ones.

Can the new flat roof go right over the old one?

Sometimes. Broward's hurricane-zone code allows one additional roofing system over the original if the existing assembly qualifies. That means passing uplift or fastener tests and a moisture survey, with no more than 5% moisture in the membrane. Soaked or rotted sheathing has to be replaced first, which means opening the roof in those spots.

Ready to get started in Davie?

Request a free estimate